iMX7 Dual Developer's Kit
[High Resolution Photos]
iMX7 Dual Developer's Kit

Embedded Artists' iMX7 Dual Developer's Kit lets you get up-and-running quickly with the iMX7 Dual COM Board. All relevant interfaces are available for prototyping/evaluating your product!

The on-board mini-PCIe, SDIO and XBee™ interfaces makes it very simple to add RF solutions.

See Display Solutions for COM boards for details about how easy it is to add a display to your project!

See our EACOM Selection Guide if you need help finding a suitable EACOM board.

 

 

TouchGFX Graphical Demo on iMX6UL / iMX7D

Benefits of having a heterogeneous Cortex-M4 core
(video presents the benefits on the i.MX 6SoloX, but the benefits are the same on the i.MX 7Dual)

 

Specification

The iMX7 Dual Developer's Kit is an Evaluation product. The individual boards in the kit are Integration products, see respective product page.

COM Carrier Board specification

The information listed below for the COM Carrier Board is valid when the iMX7 Dual COM board is used. The COM Carrier Board has more interface connectors than listed below, but these interfaces are not supported by the i.MX 7Dual processor.

Connectors and
Interfaces
• MXM3, 314-pos connector with standoffs for COM boards
• 10/100/1000 Mbps Ethernet RJ45 connector
• USB OTG interface with ESD protection
• Dual USB Host interfaces (via USB Hub) with ESD protection
• uSD/MMC connector (MMC is in parallel with uSD, so either one can be used but not both)
• Dual CAN transceivers with ESD protection and optional termination, accessible via Molex Micro-Fit 3.0 connectors
• Internal UART connectors (compatible with FTDI cables)
• XBee™ compatible interface connector
• Mini PCIe connector for half and full-size cards, including SIM card holder and USB interface
• FPC connectors for parallel camera interface
• Parallel 24-bit RGB display interface 
• Expansion connectors for many COM Board signals
• Audio codec with line out 3.5mm audio jack connector (with internal connector for microphone and line input and headphone output)
Power • 12V (+-30%) supply voltage, either via internal ATX connector or via external Molex Micro-Fit 3.0 connector
• Reverse polarity protection
• Internal 3.3V/4A and 5V/3A (and 3.3V/3A for PCIe) DC/DC converters with high efficiency
• Li-Ion / Li-Polymer battery charger for COM board RTC (note: battery not included)
Dimensions • 165 x 104 mm (same size as a typical 7 inch LCD)
• Five M3 holes for mounting and grounding
Other • On/Off and Reset pushbuttons
• Input current measurement

Included in kit

  • One iMX7 Dual COM Board (EAC00274)
  • One COM Carrier Board (EAC00246)
  • One Molex Micro-Fit 3.0 2-pos connector with 30 cm cables
  • One Molex Micro-Fit 3.0 10-pos connector with 30 cm cables
  • One micro-B to A USB Cable
  • One FTDI cable (UART-to-USB bridge for console output)
  • One Debug interface board with 10-pos FPC cable
  • The included 12V/2A power supply has interchangeable AC plug for EU, UK, US, AUS, KOR and CHN 

Related Products