COM Carrier Board
[High Resolution Photos]
COM Carrier Board

Embedded Artists' COM Carrier Board is designed for integration. Together with a COM board a Single Board Computer (SBC) solution is created, ready to be integrated into your product immediately!

The on-board mini-PCIe, SDIO and XBee™ interfaces makes it very simple to add RF solutions.

See Display Solutions for COM boards for details about how easy it is to add a display with the help of the COM Display Adapter reference design.

The COM Carrier Board is compatible with the following COM boards:

Mechanical solutions exist for the carrier board. Contact Embedded Artists for more information.


Connectors and
Note that the used COM board must support the specific interface to make use of the carrier board interfaces/connectors.
• MXM3, 314-pos connector with standoffs for COM boards
• Dual 10/100/1000 Mbps Ethernet RJ45 connectors
• USB OTG interface with ESD protection
• Dual USB Host interfaces (via USB Hub) with ESD protection
• HDMI connector with ESD protection
• uSD/MMC connector (MMC is in parallel with uSD, so either one can be used but not both)
• Dual CAN transceivers with ESD protection and optional termination, accessible via Molex Micro-Fit 3.0 connectors
• SATA connector
• Internal UART connectors (compatible with FTDI cables)
• XBee™ compatible interface connector
• Mini PCIe connector for half and full-size cards, including SIM card holder and USB interface
• FPC connectors for serial and parallel camera interface and serial display output (MIPI-DSI)
• Dual LVDS connectors
• Parallel RGB display interface connector 
• Expansion connectors for many COM Board signals
• Audio codec with line out 3.5mm audio jack connector (with internal connector for microphone and line input and headphone output)
Power • 12V (+-30%) supply voltage, either via internal ATX connector or via external Molex Micro-Fit 3.0 connector
• Reverse polarity protection
• Internal 3.3V/4A and 5V/3A (and 3.3V/3A for PCIe) DC/DC converters with high efficiency
• Li-Ion / Li-Polymer battery charger for COM board RTC (note: battery not included)
Dimensions • 165 x 104 mm (same size as a typical 7 inch LCD).
• Five M3 holes for mounting and grounding
Other • On/Off and Reset pushbuttons
• Input current measurement
Product Classification
and Status
Integration board; Volume

Documentation and Resources


Included in kit

  • One COM Carrier Board (EAC00246)
  • Note that (Li-Ion or coin cell) battery is not included

Related Products